Power Flushing

Sludge can build up in your central heating pipes stopping or restricting flow to your radiators. This will make your boiler and heating work inefficiently. Your boiler will be burning more gas to try and heat a blocked system. This causes higher fuel bills and will increase maintenance breakdown costs.


Bexley Plumbing are fully trained by Kamco to safely undertake power flushing to achieve a high success rate in making your heating system more efficient and reduce your heating bills.


How It Works

Power Flushing Bromley 4The CLEARFLOW power flushing pump is simply connected into the heating system, either across standard circulator pump couplings, across the tails of one radiator, or wherever most practicable. The powerful flow, combined with instantaneous flow reverser device, will dislodge and mobilise deposits and corrosion which resist traditional system cleaning methods.


Once the corrosion and sludge deposits have been loosened and mobilised, fresh clean water is forced through the heating system, pushing the contaminated water out through a full bore dump valve to waste. During the CLEARFLOW process, radiators are individually flushed, without removing or disconnecting them from the system, by directing the full output of the pump through each radiator separately.


At the end of the flushing process, the system contains fresh clean water and reinstatement of the system to normal operation takes only a few minutes.


System flushing will not remedy design or mechanical faults, which should be rectified, but in many cases it will cure the problems caused by these.


Call Bexley Plumbing, Tel: 0203 793 8337 to book your Power Flushing appointment